Con-tech CS2000-QD Manuel d'utilisateur télécharger pdf (Page 13)

- 11 -

Missing Label Compensation

Overview:

 The CS2000 has the capability to detect a single missing label and output a stop pulse as

though the label were present. In order for Missing Label Compensation to function properly the

operator must first: a) have Pulse Output selected - see Program Mode (page 12) for more

information. b) adjust the label sensitivity - see Easy Setup (page 10) for more information. c)

have the labeling machine set to desired speed.

Enabling Missing Label Compensation:

 1.  Make sure a label is under the sensing area.

 2.  Depress the push-button until the green LED begins flashing at a slow rate

  (

5 sec.), then release. If the green LED flashes at a fast rate it indicates that the 

  label was not positioned correctly and you need to start over.

 3

.  Jog 1 label.

Missing Label Compensation is now enabled and should function correctly.

Disabling Missing Label Compensation:

 1.  Depress the push-button until the green LED begins flashing (5 sec.), then release.



 2

.  Depress the push-button once again to disable.

*You can also disable Missing Label Compensation by selecting Level Shift Output. Refer to

Program Mode (page 12) for more information.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Con-tech CS2000-QD Manuel d'utilisateur Page 13